BBÖ 1470.001 color scheme

Hello everyone,

I am building the model of the BBÖ 1470.001 locomotive and I am looking for the correct color scheme.
The typical color scheme for Austrian electric locomotives should have the frame painted black and the body in "tannengrun" Ral 6009 but since it was only a prototype of a locomotive could it perhaps have another color scheme?
For example, all black both the lower frame and the upper body?
I would be very grateful if there was someone who could give me useful information to complete the model.

See you soon and best regards

Beppe

Hi Michael,

many thanks for your comment about the 1470 color layout and I hope to receive other suggestions from forum friends in order to have a cross comparison and a useful discussion.

Anyway this is a good starting point.

Concerning the loco kit it was prepared by Giorgio and this kit is the first and only kit prepared up to now.

I hope to show the first assembly steps during the next days.

Thank you very much again.

Beppe

Dear friends,

many thanks again for your comments and contributions.

I understood what should be the color I should use but I have some considerable doubts.

Looking at all the photographs available to me, if the machine had been painted moss green, I should see images with the body tending towards grey, perhaps dark grey, since the photos were in black and white. Instead, I seem to see the locomotive body as black, better still shiny black. I would not want this machine to be painted black since it is a preliminary prototype. Another twin machine of this one, built for the FS, the locomotive E 471, also built in a single example, again by Eng. Kalman Kando from CEMSA in Saronno, practically a twin of your machine 1470, was painted black.
Since it was perhaps never officially delivered to the BBÖ, perhaps it also remained painted black. We will see what to do.
In any case, I am attaching some images of the model under construction.
See you soon and thanks again.

Beppe

Dear all,

the work continues, slowly but steadily....

Beppe

Dear friend,

I would have an explanation about the BBÖ pantograph.

The picture shows the loco pantograph that have two different

electric sliding contacts, a smaller one at inner side and a larger one.

Why this solution applied only on austian railway ?

Could I have a technical document or technical description that explain this ?

Many thanks

Beppe

Dear freinds,

the work continues and we are at the completion of the upper body of the model. I am waiting for the new gears needed for the new transmission that will then be inserted into the locomotive frame.
As usual I am sending some images of the model.
See you soon
Beppe